Replacing The Projection Lamp - InFocus RP10s User Manual

Replacing the Projection Lamp

7KH ODPS KRXU WLPHU LQ WKH 6HUYL.H ,QIR PHQX .RXQWV WKH QXPEHU
RI KRXUV WKH ODPS KDV EHHQ LQ XVH :KHQ WKH WLPHU UHD.KHV 
KRXUV WKH $ODUP /(' OLJKWV UHG LQGL.DWLQJ WKDW LW LV WLPH WR
.KDQJH WKH ODPS <RX .DQ RUGHU QHZ ODPS KRXVLQJV IURP \RXU
,Q)R.XV GHDOHU 6HH ´$..HVVRULHVµ RQ SDJH  IRU LQIRUPDWLRQ
)ROORZ WKHVH VWHSV WR UHSOD.H WKH SURMH.WLRQ ODPS
1 7XUQ RII WKH SURMH.WRU DQG XQSOXJ WKH SRZHU .RUG
2 :DLW  PLQXWHV WR DOORZ WKH SURMH.WRU WR .RRO WKRURXJKO\
3 /RRVHQ WKH WKUHH .DSWLYH V.UHZV RQ WKH ODPS KRXVLQJ
4 &DUHIXOO\ UHPRYH WKH ODPS KRXVLQJ 'LVSRVH RI WKH ODPS LQ DQ
HQYLURQPHQWDOO\ SURSHU PDQQHU
Loosening the screws on the lamp housing
WARNING: To avoid burns,
allow the projector to cool for at
least 60 minutes before you
replace the lamp. Never extract
the lamp housing while the projec-
tor is operating.
WARNING: Be extremely careful
when removing the lamp housing.
In the unlikely event that the bulb
ruptures, small glass fragments
may be generated. The lamp mod-
ule is designed to contain these
fragments, but use caution when
removing the lamp module.
F 23
IGURE
31