Showing Ip Addresses; Changing Ip Addresses; Editing Network Settings - HELIX Broadcaster 100 User Manual

Helix Broadcaster 100 Touch Screen User Guide

Showing IP Addresses

Enter
page 4) is listed as
WAN address is shown below in
...
3: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 08:60:6e:44:0c:0a brd ff:ff:ff:ff:ff:ff
inet 10.125.15.250/24 brd 10.125.15.255 scope global eth0
inet6 fe80::a60:6eff:fe44:c0a/64 scope link
...

Changing IP Addresses

Enter
(the second character is a zero) at the submenu:
e0
e0)
e1)
g)
IP Address Setup Screen
In the setup screen, use the arrow keys to navigate to the end of the IP address. Press
to erase the characters. Enter the new address, press
Press

Editing Network Settings

Enter
submenu:
e0)
e1)
g)
at the main menu to display the current IP address settings. The WAN address (see
4
. Additional IP addresses are
eth0
valid_lft forever preferred_lft forever
at the main menu to change an IP address. To set the WAN address (see page 3), enter
1
Edit WAN Settings (ctrl-x to exit)
Edit LAN #1 Settings
Edit Default Gateway and DNS Settings
to return to the main menu.
x
at the main menu to change network settings such as DHCP (see page 3). Enter
1
Edit WAN Settings (ctrl-x to exit)
Edit LAN #1 Settings
Edit Default Gateway and DNS Settings
,
eth1
:
bold
Ctrl+x
APPENDIX A: Console Setup
, and so on. For example, the IPv4
eth2
to exit, and to confirm the changes.
Y
Backspace
at the
g
34