Advertisement
■ Optical Parts Disassemblies
3-
1
Prism ass'y removal and disassembly
1
A
Remove 4 hex screws
2
Remove each 1 screw
Optical filter, Polarized Glass-Out upwards off. These glasses are mounted
for R, G and B LCD panels respectively.
Note:
To avoid the CG and focus alignments slipping off, please be careful to han-
dle the LCD/Prism ass'y.
Note:
Do not replace the LCD panel
separately otherwise it can
not obtain proper picture.
Fig.3-
1
3-
2
Polarized glass and optical filter mounting direction
The polarized glasses and optical filters in the prism assembly are installed
as figure below. Please be careful for the mounting.
The polarized glasses are placed as the film attached face comes to panel
side.
The optical filters are placed as the face on which the part no. is printed
comes to the panel side as shown in the figure. The optical filters for B and G
panel have films on the both of the faces.
Film
1 A V 4 Z
Optical Filter(WV)
Fig.3-
4
and take the LCD/Prism ass'y off upward.
B
and take the Glass Holder, and then pull the
A
A
A
A
Polarized Glass
0
1 5 B 1 8
Optical Filter(WV)
* Glasses should be placed as the
sheet attached side comes to the
LCD panel side.
G-PANEL
Polarized Glass
Fig.3-
3
-3-
Polarized Glass-
B
Out
Optical Filter
Fig.3-
Optical Filter(WV)
Polarized Glass
PRISM
PRISM
PRISM
Polarized Glass
Optical Filter(WV)
2
Advertisement
