TROUBLESHOOTING
Timer Recording
Timer programming cannot be made.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 81)
●
Timer recording is in progress.
] Timer programming can't be performed while a timer recording
is in progress. Wait until it finishes.
Timer programming recording does not start.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 81)
VIDEO Plus+ Timer Programming cannot be made.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 81)
●
The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(A pg. 19, 77)
The VIDEO Plus+ system does not timer record properly.
●
The unit's channel positions have been set incorrectly.
] Refer to AGuide Programme Number SetB (A pg. 77) and re-
perform the procedure.
Automatic Satellite Programme Recording does not start.
●
The satellite receiver is not connected properly to this unit.
] Connect the satellite receiver to the unit's [L-2 INPUT/
DECODER] connector properly. (A pg. 53)
On the front display panel, A- - : - -B appears.
●
Power failure occurred.
] Set date and time correctly. (A pg. 81)
The disc space does not increase when recorded titles are
cleared.
●
The PC's data recorded on a DVD-RAM drive cannot be cleared
on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 6, 82)
APROGRAMME FULLB appears on the TV screen during timer
programming.
●
All 8 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer
programming again.
86
Audio
No sound from speakers.
●
Speaker signal cables are not connected.
] Check the speaker wiring, then reconnect if necessary.
●
An incorrect input mode (analogue or digital) is selected.
] Select the correct input mode (analogue or digital).
●
TV DIRECT mode is activated.
] The subwoofer turns off automatically once the TV DIRECT
mode is set, thus there is no sound output from the speakers.
Please make use of your TV's speakers.
●
The system cable is not connected.
] Connect the system cable.
Hissing or buzzing sound during FM reception.
●
Incoming signal is too weak.
] Connect an outdoor FM antenna or contact your dealer.
●
The broadcast station is too far away.
] Select another broadcast station.
Noise during FM/AM reception.
●
The wrong antenna is being used.
] Check with your dealer to ensure you have the correct antenna.
●
Antennas are not connected properly.
] Check the connections.
●
Ignition noise from automobiles.
] Move the antenna further away from automobile traffic.
ADSP NGB appears on the front display panel.
●
The built-in processor is not functioning properly.
] Press A on the front panel to turn off the unit.
Remove the power cord and contact your dealer.