Rancilio epoca S Use And Maintenance Manual page 12

1. Main switch
Two-position switch with LED.
Push the switch(LED on), the machine is
powered(except for the element), and the pump
is turned on to fill the boiler.
2. Boiler resistance switch
Two-position switch with LED.
Push the switch(LED on), and power is supplied
to the element for heating the boiler water.
3-4. Coffee dispensing switch (mod. CD)
Press and release the button(LED on), coffee
is continuously dispensed. Press and release
the button again and coffee stops.
5. Coffee dispensing electronic panel (mod. DE)
This panel features 5 buttons for each dispenser:
Four buttons for dispensing the programmed
coffee dose.
One button for:
- Stopping coffee dispensing
- Starting continuous coffee dispensing
- Initializing dose programming(hold button
for 8-10 seconds)
Each time coffee is dispensed, the LED of the
relative button lights up.
During dose programming, the LED of the 5th button
flashes rapidly
6. Hot water supply knob
Turn in a counter-clockwise direction to open;
and clockwise to close the tap.
7. Steam supply knob
Turn in a counter-clockwise direction to open;
and clockwise to close the tap.
8. Supplemental manual water supply valve
Positioned under the drip-tray. Press down to fill
the boiler manually.
Safety Devices
Dispensing cannot begin until the machine has
reached the operating pressure or temperature.
Dispensing will stop each time the boiler
pressure drops too low.
11
7.2. Control Instruments
9 Gauge with mobile needle on a fixed dial with a
scale and color indicators.
Visual control of the boiler pressure.
10 Minimum and maximum water level indicator.
Visual control of water level in boiler(green LED).
12 Cup warmer switch (optional).
7.3. Starting up
Turn on the water supply tap 2 (Fig. 6).
Push the main switch 1; the pump is activated to
fill the boiler.
When the water reaches the correct level, the
pump stops. Then push the main switch 2 to begin
heating the water in the boiler.
Wait for the machine to reach its working pressure,
(gauge needle 9 in green area), and for the machine
to reach its correct thermal balance.
(Fig. 8)