Dust Collection - Makita LC1230 Instruction Manual

For European countries
2
1
004708
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
depress the lever to release the handle from the fully
elevated position and to press in the lock-off button, and
then pull the switch trigger. Release the switch trigger to
stop.
For all countries other than European countries
1
003773
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
Setting for desired cutting angle
CAUTION:
Always tighten the hex bolt securely after changing
•
the cutting angle.
1
2
003774
To change the cutting angle, loosen the lever. Move the
vise stop so that the indicator will point to the desired
graduation. Then tighten the lever to secure the vise
stop.
1. Lock-off button
3
2. Lever
3. Handle
4. Switch trigger
4
1. Lock-off button
2. Switch trigger
2
1. Graduation
3
2. Lever
3. indicator
4. Vise stop
4

Dust collection

003775
CAUTION:
Do not touch any part of the dust box except its
•
handle immediately after operation; it may be
extremely hot and could burn your skin.
This tool is equipped with the dust box to collect dust and
cut chips. When the dust box is full, hold the handle of the
dust box and raise it slightly. Then pull the dust box out of
the tool base. Empty the dust box of its contents.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Socket wrench storage
1
2
003776
The socket wrench is stored as shown in the figure.
When using the socket wrench, pull it out of the wrench
holder. After using the socket wrench, return it to the
wrench holder.
Installing or removing saw blade
1
4
003777
5
1. Dust box
1
1. Wrench holder
2. Base
1. Center cover
2
2. Hex bolt
3. Socket wrench
4. Blade guard
3