Specifications - Makita LC1230 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Hole (arbor) diameter
No load speed (min
Dimensions (L x W x H)
Cutting capacity
Workpiece shape
Cutting angle
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Model
Blade diameter
-1
)
Net weight
Safety class
90°
45°
equipment
END205-3
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.25 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
and its
characteristics.
2
LC1230
305 mm
25.4 mm
1,300
516 mm x 306 mm x 603 mm
19.3kg
/II
A
A X B
115mm 75 mm x 150 mm 100 mm x 100 mm
90mm
B
A
85 mm x 85mm
ENE008-1
ENF002-2
ENF100-1