Selecting The Source To Play; Adjusting The Volume [Volume]; Listening With Headphones (Not Supplied); Turning Off The Sound Temporarily [Muting] - JVC GVT0155-001A Instructions Manual

Basic operations
Selecting the source to
play
On the remote control:
Press one of the source selecting buttons
(DVD/CD3, FM/AM or TV SOUND).
DVD/CD3: To play back a disc (DVD VIDEO, VCD etc.). (See
page 16.)
To tune in an FM or AM (MW) station. (See page
FM/AM:
34.)
Each time you press the button, the band alternates
between FM and AM (MW).
TV SOUND: To select the TV (that outputs sound signals)
connected to the AV (SCART) connector. (See page
11.)
On the center unit:
Press SOURCE repeatedly until the source
name you want appears on the display
window.
NOTE
• When a source except DVD is selected, this system does not output
video signals.
• It may take time to change the source.
Adjusting the volume
[VOLUME]
CAUTION
• Always set the volume to minimum level before starting any source.
If the volume is set at its high level, the sudden blast of sound could
permanently damage your hearing and/or blow out the speakers.
On the remote control:
Press AUDIO VOL +/–.
On the center unit:
Turn VOLUME.
Listening with headphones
(not supplied)
CAUTION
Be sure to turn down the volume;
• Before connecting or putting on headphones as high volume may
damage both the headphones and your hearing.
• Before disconnecting headphones as high volume may be suddenly
output from the speakers.
While connecting a pair of headphones to the PHONES jack on the
center unit, the system automatically cancels the surround mode
(see page 20) currently selected, deactivates the speakers, and
activates the headphone mode. "H.PHONE" appears on the display
window.
Headphone mode
When using the headphones, the following signals are output
regardless of your speaker setting;
• For 2 channel sources, the front left and right channel signals are
output from the headphones.
• Multi-channel signals are down-mixed and output from the
headphones.
Turning off the sound
temporarily [MUTING]
Press MUTING.
To restore the sound
Perform one on the following:
• Press MUTING again.
• Press AUDIO VOL +/– (or turn VOLUME on the center unit).
Adjusting the brightness
of the indications
[DIMMER]
Press DIMMER, with SHIFT pressed.
Each time you repeat the procedure, the brightness level changes.
See page 13 for button locations.
14