Table of Contents
Advertisement
• Press
ON "X" MIN
to water those stations for the desired
("X") number of minutes.
To Cancel Remote Control Device Operation
and Return Control to Timer:
• Press the
OFF/CLEAR
This cancels any current commands from the device
and returns control back to the timer.
Section 5:
Using the Optional
Rain-Freeze Sensor
An optional rain-freeze sensor can be purchased separately to
prevent programmed watering for a specified period of time
after rain falls or during periods when temperatures fall below
a specified temperature. The sensor has settings for RAIN,
and RAIN/FREEZE. Please refer to the manual that accompanies
the rain-freeze sensor for installation and programming instruc-
tions.
NOTE: The rain-freeze sensor will function only when the selection
dial on the timer is turned to AUTO.
Section 6:
Installing Indoor Mount
Sprinkler Timer and Remote
Control Device Sleeve
NOTE: Before installation, please have the following tools on hand:
• Phillips screwdriver
• Wire strippers
12
button on the Remote Control Device.
Installing the Sprinkler Timer
in Five Easy Steps
1. Select a Location
Select a location with the following criteria:
• Near an electrical outlet. (Avoid using an outlet controlled
by a switch.)
• In a dry, indoor location, where operating temperatures
are not below 32° or above 122° Fahrenheit (below 0
degrees or above 50 degrees Celsius).
• Not in direct sunlight.
• Accessible to sprinkler wires from valves.
OFF
ACTIVE
Figure 3: Mounting the Docking Port
RF SYNC
BYPASS
Slide the Timer off the Docking Port
SENSOR
COM
PUMP
1
2
3
4
5
6
7
8
9
10
11
12
24 VAC
Hide quick links:
Advertisement
Table of Contents
