Installing a memory module
To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the one screw securing the memory module cover in place -
please note that this screw is attached to the cover in order to prevent it
from being lost.
Use a point size 0 Phillips screwdriver.
6. Slide your fingernail or a thin object under the cover and lift it off.
1. Memory module cover
User's Manual
Turning off the power
Figure 3-3 Removing the memory module cover
section in Chapter 1,
section in Chapter 6,
2. Screw
Satellite A660/A665
Getting
Started, if
Power and Power-Up
2
1
3-22