Delta 36-960 Instruction Manual page 15

Fig. 52
Fig. 51, illustrates the miter gage and wrenches stored on
the two holder brackets .
ASSEMBLING RIP FENCE HOLDER
B R A C K E T S
Assemble the rip fence holder brackets (A) and (B) Fig.
52, to the four holes located in the right hand side of the
" sheet metal screws supplied.
1
saw cabinet using four /
2
Figure 53 illustrates the Biesemeyer fence (C), (when not
in use), positioned on the two holder brackets .
ATTACHING LITERATURE HOLDER
TO SAW CABINET
A literature holder (A) Fig. 54, is supplied with your saw to
provide storage and protection for the machine s
instruction manual, pa r ts l i s t , e t c . , s o t h e y m a y b e r e a d i l y
available for reference. Two push rivets (B) are supplied to
a t tach the literature holder to the right side of the saw
cabinet, as shown in Fig. 54.
FENCE OPERATION
IMPORTA N T: Before operating fence, make
sure the fence is adjusted parallel to the miter
gage slot, as explained later on in this manual.
1 . To p l a c e t h e f e n c e o n t h e g u i d e r a i l , l i ft up clamp (A)
Fig. 55, and place the fence over the rail and gently push
f e n c e o n t o r a i l ( B ) F i g . 5 5 .
2 . To move the fence along the guide rail, simply lift u p
clamp lever (A) as shown in Fig. 55, slide fence to desired
position on rail, and push down on clamp lever (A) Fig. 56,
B
A
A
15
C
Fig. 53
B
Fig. 54
A
B
Fig. 55
A
B
Fig. 56