Philips OR2000M User Manual

Mini radio
Hide thumbs

Advertisement

Quick Links

Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Question?
Contact
Contact
Philips
Philips
User manual
OR2000M

Advertisement

loading

  Related Manuals for Philips OR2000M

  Summary of Contents for Philips OR2000M

  • Page 1 Always there to help you Register your product and get support at www.philips.com/welcome OR2000M Question? Question? Contact Contact Philips Philips User manual...
  • Page 3: Table Of Contents

    Contents 1 Safety 2 What's in the box 3 Connect power 4 Power on 5 Adjust volume 6 Listen to radio 7 Listen to an external device 8 Troubleshooting 9 Product information General information Tuner Speakers Amplifier 10 Notice Compliance Care of the environment Copyright...
  • Page 4: Safety

    1 Safety • Do not place any sources of danger on this product (e.g. liquid filled objects, lighted candles). • Never place the product or any objects Read and understand all instructions before you on power cords or on other electrical use this product.
  • Page 5: What's In The Box

    2 What's in the Check and identify the contents of the package: OR2000M User Manual...
  • Page 6: Connect Power

    3 Connect power Connect the power plug to the AC power outlet.
  • Page 7: Power On

    4 Power on Turn the left knob clockwise until you hear a "click" sound. • To power off, turn the left knob anti- clockwise until you hear a "click" sound.
  • Page 8: Adjust Volume

    5 Adjust volume • To increase the volume, turn the left knob clockwise. • To decrease the volume, turn the left knob anti-clockwise.
  • Page 9: Listen To Radio

    6 Listen to radio Note • For optimal reception, fully extend the antenna and adjust its position, or connect an outdoor antenna. Press down FM/MW to switch the tuner band to MW. • To switch the tuner band to FM, press FM/MW again to release it.
  • Page 10: Listen To An External Device

    7 Listen to an external device You can also listen to an external audio device, for example, MP3 player, through this product. Connect an audio input cable with a 3.5 mm connector on both ends to • the AUDIO-IN socket on the back panel of this product, and • the headphone socket on the external device.
  • Page 11: Troubleshooting

    If you encounter problems when using this product, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.
  • Page 12: Product Information

    9 Product Speakers information Speaker Impedance 8 Ohm Speaker Driver 3" full range Sensitivity > 82 dB/m/W Note • Product information is subject to change without prior notice. Amplifier Output Power 3 W RMS Frequency Response 60 Hz - 16 kHz, General information ±3 dB Signal to Noise Ratio...
  • Page 13: Notice

    2014 © WOOX Innovations Limited. All rights This is CLASS II apparatus with double reserved. insulation, and no protective earth provided. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited Care of the environment under license from Koninklijke Philips N.V.
  • Page 14 WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.