Table of Contents
Advertisement
VC732000MUK Rev1_Instruction Book 13/12/2013 14:57 Page 9
IMPORTANT: Do not use heated appliances to
dry filters.
Replace the filter into the dust canister
4.
replace the dust canister back onto the handheld
vacuum cleaner (12).
Replace the handheld vacuum cleaner back into
5.
the main vacuum cleaner body
cleaning.
Maintenance - troubleshooting
• "Does not pick-up"/ "Motorized floor-brush
running slow or soon stops"
Check for hairs/fibres that may be wrapped
around the rotating brush-bar.
IMPORTANT: Remove the brush bar as described
on page 6. Fine hairs or fibres may be caught
unseen in the ends of the brush bar. Carefully
remove the hairs and re-fit the brush bar.
• "Does not pick-up" / "Suction of handheld
cleaner has reduced"
In addition to emptying the dust canister, it is very
important that the filters inside the handheld
cleaner are regularly and thoroughly cleaned. See
page 8 for details of how to access and clean the
filter.
• "Does not pick-up from the floor but the floor
brush is rotating and the handheld has good
suction"
Switch off the product, remove the motorised floor
brush and check for blockages in the connector
between the motorised floor brush and the main
vacuum cleaner body.
• "Product not charging"
Check the indicator light
handheld cleaner is glowing red to indicate that
charging is in process. If the indicator is not
showing red, check: a) the product is correctly
seated on the charging cradle; b) the mains plug is
fully fitted into the mains socket and the socket is
switched on. If these are OK, check the fuse in the
mains plug.
(13)
then
1.
(7)
if upright
2.
3.
(11)
on the front of the
4.
Storage
Fit the handheld vacuum cleaner
the cavity on the main vacuum cleaner body
firstly sliding the suction end into place over the
suction hole in the main vacuum cleaner body
cavity, then push the handle end in to place until a
click is heard.
Insert the assembled upright unit into the
charging cradle (15).
The upright handle
(4)
is collapsible for compact
storage by pressing the upright handle release
button (6).
Place the tools onto the accessory holder
(see 'Tool storage', page 8).
WARNING: When locking the handle, keep this
area clear. Be careful not to trap your fingers or
any loose items of clothing etc.
(12)
back into
(7)
by
(16)
9
Hide quick links:
Advertisement
Table of Contents
