Korg i2 HD Installation Manual page 3

5. Installing the i2/i3 HDisk Board in normal version instruments
(yellow operating system EPROM).
a) Unscrew the screw which holds the "Main Board" in place (see illustration 2). Screw the spacer
bolt supplied into this hole.
b) Pull the female connector of the ribbon cable leading to the Style Card slot out of the CN15A
socket.
Connect the grey female connector of the i2/i3 Hard-Disk Board to the CN15A socket and
c)
screw the board onto the spacer bolt installed in step a) (lower hole of the i2/i3 Hard-Disk Board).
d) Connect the female connector of the Style Card slot to the black male connector located at the
upper end of the i2/i3 Hard-Disk Board.
Connect the ribbon cable supplied to the male connector located on the left bottom side of the
e)
i2/i3 Hard-Disk Board. Connect the other female connector of the ribbon cable to the male
connector of the hard disk.
f) Pull the protective foil off the adhesive tapes and stick the hard disk to the bottom side of the
i2/i3's enclosure ( below the ribbon cable leading to the floppy drive).
g) Reassemble the keyboard.
6. Installing the i2/i3 HDisk Board in EX version instruments
(red operating system EPROM)
a) Unscrew the screw by which the "i2/i3 Style EX" board is attached to the "Main Board" by means
of a spacer bolt (see illustration 2). Screw the spacer bolt supplied into this hole.
b) Pull the female connector of the ribbon cable leading to the Style Card slot out of the socket of
the "i2/i3 Style EX" board.
Connect the grey female connector of the "i2/i3 HDisk" Board to the male connector of the
c)
"i2/i3 Style EX" board and screw the board into the spacer bolt installed in step a) (upper hole of
the i2/i3 HDisk Board). In addition you can use the cable strap to hold the i2/i3 HDisk Board in
place. To do so, insert the cable strap into the remaining hole of the i2/i3 HDisk Board, pull it
around the i2/i3 Style EX board and tighten the cable strap.
d) Connect the ribbon cable supplied to the male connector located on the left bottom side of the
i2/i3 HDisk Board. Connect the other female connector of the ribbon cable to the male connector
of the hard disk.
Connect the female connector of the Style Card slot to the black male connector located at the
e)
top end of the "i2/i3 HDisk Board".
f) Pull the protective foil off the adhesive tapes and stick the hard disk to the bottom side of the
i2/i3's enclosure ( below the ribbon cable leading to the floppy drive).
g) Reassemble the keyboard.