Table of Contents
Advertisement
Changing the Z-2400-Sleeper Battery:
1.
Power off the Sleeper by putting the 8th bit of Dip Switch B to the "OFF" position.
2.
Remove the DIN rail clip from the rear of the Sleeper by levering the lower end with a screwdriver, while
simultaneously sliding the clip towards the centre with your other hand; removal of the red clip does not need a lot
of force, the key is to lever the screw driver in carefully. Keep the DIN rail clip in a safe place, and do not lose the
spring.
3.
Use a small screwdriver to lever up the back and side clips as shown in the images below. Once all four clips
have been released, gently ease the two covers apart.
4.
Remove the old battery and replace it with a new one, as shown.
10
Advertisement
Table of Contents
