Sanyo LCD-32XR9DA Service Manual page 10

f) Check logical channel number (LCN) for France, UK and Italy.
g) Check OTA function for Australia special custom.
6. Presetting before ex-factory
Enter user menu LOCK page, select "Restore Factory Default" to preset the ex-factory.
a) Clear the program information.
b) Clear VCHIP, parental control, etc.
c) Set the default data of user menu.
d) Set Menu Language to English.
e) Set Power on Mode to Off.
7. Software instruction
No. Code No.
N810 5272532003
N807 5272404002
NA03 5272402002
NA04 5272402002
NA08 5272402002
N107 5272421002
Note1: write-protect setting: enter ALL-100 interface, select Config and press "config setting", set
Protect to "All Protect", select "config" when writing. The "write-protect" will be set again when
ALL-100 program restart.
Note2: software writing and upgrade method with ISP writing-device
(1) Main board upgrade: connect a four-pin wire of the ISP writing-device to Debug port(X806)
on the main board; Unit upgrade: connect VGA ports of the ISP writing-device and the main
board, enter factory menu and set "ISP Mode" to "ON".
(2) Using Mstar writing-tool on line, click "Connect" menu, if it displays "Device EN25B32" as
shown in fig2, the connection is success, if it fails, select "EN25B52" of "Device" manually
and press "Connect" again.
Table5 software instruction
Type Function
EN25B32-100HIP FLASH
AT24C04 HDMI KEY
AT24C02 HDMI EDID
AT24C02 HDMI EDID
HDMI
AT24C02
(Australia only)
AT24LC21A VGA EDID
written before
paste
Yes
Yes
Yes
Yes
Yes
EDID
Yes
8
Method
Written with device like ALL11,
write-protect, refer to note1.
Written with device like ALL11