Frigidaire FRF170FF Instruction Manual page 9

SAfETY
WARNINg
IT IS HAZARDOUS FOR ANYONe
OTHeR THAN AUTHORISeD SeRVICe
PeRSONNeL TO CARRY OUT
SeRVICINg OR RePAIRS WHICH
INVOLVe THe ReMOVAL OF COVeRS.
TO AVOID THe RISK OF AN
eLeCTRIC SHOCK DO NOT ATTeMPT
RePAIRS YOURSeLF.
Disposal
Old appliances still have some residual value. An environmentally friendly
method of disposal will ensure that valuable raw materials can be
recovered and used again. The refrigerant used in your appliance and
insulation materials require special disposal procedures. ensure that none
of the pipes on the back of the appliance are damaged prior to disposal.
Up to date information concerning options for disposing of your old
appliance and packaging from the new one can be obtained from your
retailer or local council office.
Locks
If your upright freezer is fitted with a lock, to prevent children being
entrapped keep the key out of reach and not in the vicinity of the appliance.
If disposing of an old freezer break off any old locks or latches as a safeguard.
electrical Connections
THIS APPLIANCe MUST Be eARTHeD.
This appliance is fitted with a fused three pin plug to BS 1363
which will be suitable for use in all houses fitted with sockets to
current specifications. If the fitted plug is not suitable for your socket
outlets, it should be cut off and carefully disposed of. To avoid a possible
shock hazard, do not insert the discarded plug into a socket.
Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead must
be connected as shown here.
CONNeCT
BLUe TO
NeUTRAL (N)
MAKe SURe THe CABLe IS HeLD
BY THe CLAMP
The wires in the mains lead fitted to this appliance are coloured in accordance
with the following code:
If the colours of the wires in the mains lead of this appliance do not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and Yellow MUST be connected to the
terminal which is marked with the letter e (earth) or symbol or coloured green.
The wire which is coloured Blue MUST be connected to the terminal which is
marked with the letter N or coloured Black. The wire which is
Brown MUST be connected to the terminal which is marked with the letter L
or coloured Red.
Before refitting the plug cover, check that there are no cut or stray strands of
wire inside the plug.
Use a 13 Amp BS1362 fuse, only BSI or ASTA approved fuses should be used.
If you are in any way unsure which plug or fuse to use, always refer to a
qualified electrician.
Note: After replacing or changing a fuse on a moulded plug which has a fuse
cover, the cover must be refitted to the plug, the appliance must not be used
without a fuse cover. If lost, replacement fuse covers can be obtained from an
electrical shop.
This appliance complies with the following eeC Directives: 73 / 23 eeC
(Low Voltage Directive) 89 / 336 eeC (eMC Directive).
CONNeCT gReeN
AND YeLLOW TO eARTH (e) (Note:
some appliances do not have earth
wires.)
CONNeCT
BROWN TO
LIVe (L)
9
coloured