JVC LT-32E488 User Manual page 23

Auto Tuner Setup
In auto tuner setup, the TV automatically scans through all available channels, memorizing the
active ones and skipping over blank ones or channels with weak signals. This means when you
scan (using the C
HANNEL
Auto Tuner Setup
Tuner Mode
Scan Mode
OK
Select Operate
When the setup is finished, "Thank you ! Setup is now complete." is displayed. Your quick
setup is now complete. You can now begin watching your television, or you can continue
on in this guide for more information on programming your remote control, or using the
JVC onscreen menu system to customize your television viewing experience.
Notes:
• You can choose Scan Mode only when Tuner Mode is Cable.
• If you want to cancel the Auto Tuner Setup, press the M
• Noise muting will not work during Auto Tuner Setup.
• If you choose "Skip", it finished without doing the Auto Tuner Setup.
Cable Users: After your auto tuner setup is complete, you may, (depending on the type of
hookup), have only 1 channel, usually 3 or 4 in the auto tuner memory. This is normal.
+/– buttons) you will receive only clear, active channels.
è
Cable
π †
Auto
è
†
Start
BACK MENU
Back Exit
Now Programming...
To choose "Cable or "Air" (or "Skip" when
you skip "Auto Tuner Setup")
To Scan Mode
To choose Auto, STD, HRC or IRC
To "Start"
Press the O button
K
8
button.
ENU
Quick Setup
23