Monoprice Speaker Volume Control with Infrared Repeater User Manual

Speaker Volume Controller
With IR Repeater
Slide type – PID#10221

Features

o Impedance matching supports up to 16 speaker pairs
o Supports up to 100 watts/channel at 8 ohms impedance
o Compatible with 12-22AWG speaker wire
o Slide type volume control with 12 steps
o Built-in single-band (38KHz ± 2KHz) IR repeater
o 2.71" (69mm) mounting depth

Package Contents

After receiving product, please inventory the contents to ensure
you have all the proper parts, as listed below. If anything is
missing or damaged, please contact Monoprice Customer
Service for a replacement.
o 1x Slide type 100 watt/channel volume control
o 2x 3/4" screws
o 2x 1/8" screws
o 1x Interior plate
o 1x Outer plate
o 1x User's manual

Installation Instructions

NOTE: The blue INPUT L/R and OUTPUT L/R speaker wire
terminal blocks can be removed from the volume control unit,
making it easier to make the speaker wire connections. To do so,
pull straight out, away from the circuit board.
1. Remove about 1/4" of insulation from the ends of all wires to
be connected to the volume control. Twist the exposed wire to
ensure no stray strands are sticking out of the bundle.
2. Connect the wires from the output of your amplifier to the
INPUT L/R terminals on the volume controller. Ensure that the
right and left channels are properly connected and that the +
and - polarity is properly maintained. Tighten the screws
firmly.
3. Connect the wires from your speakers to the OUTPUT L/R
terminals on the volume controller. Ensure that the right and
left channels are properly connected and that the + and -
polarity is properly maintained. Tighten the screws firmly.
4. (Optional) To setup the volume control to relay IR remote
control signals to the source device, perform the following
steps:
4a. Obtain a 12 VDC/500mA AC Adapter (not included) and
cut off the DC barrel connector (if applicable). Remove
about 1/4" insulation from the wires. Twist the exposed
wires to ensure no stray strands are sticking out of the
bundle.
4b. Connect the positive wire from the 12VDC/500mA adapter
to the V+ terminal on the volume control. Connect the
negative wire to the G (ground) terminal on the volume
control.
4c. Obtain an IR transmitter bulb (not included). Remove
about 1/4" insulation from the wires. Twist the exposed