JVC J3CN0321A Owner's Manual page 14

Connections to other equipment
To connect the LCD TV to a PC (Personal Computer)
Before you connect this TV to your PC, change the adjustment of your PC's Resolution and
Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case
of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the
AUDIO connector of the PC/DVI AUDIO IN jack of the TV. You can also connect the PC with HDMI cable. If you
use HDMI cable, you don't have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio
cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
Right of the unit
To PC/DVI
AUDIO IN
To HDMI IN
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
•
• When the PC connected to the HDMI terminal and 1920x1080 resolution (FHD) is selected, the top and
bottom, right and left edges of the picture may be hidden on all PICTURE SIZE. In this case, use the PC
MONITOR IN jack (VGA cable) is recommended to connect.
• When the PC's resolution is set to 1920 x 1080/60 Hz (FHD mode), a signal that differs from the FHD signal,
which has been confirmed operational on this TV, may appear depending on the PC used. In this case, "Auto
Adjust" or other Position Adjustment functions may fail to correct the image position.
To solve this problem, change the PC settings to select another resolution.
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the
TV's remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the TV's built-in speakers (see page 17).
Right of the unit
NOTE:
• To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set
above 0 (zero).
• For example, if the volume of the TV is set to 0, you will not be able to hear any sound, even if the volume of the
amplifier is at its highest level.
14
To PC
MONITOR
IN
VGA cable (not supplied)
Audio cord (not supplied)
HDMI cable (not supplied)
To VAR. AUDIO OUT
Audio cord (not supplied)
Monitor Display modes
MODE Resolution Refresh rate
VGA
VGA
SVGA
XGA
WXGA 1280x768 60Hz
WXGA 1360x768 60Hz
SXGA
WXGA+ 1440x900 60Hz
FHD
To return to normal mode
Press INPUT SELECT again.
Amplifier
To Audio (L) Input
(continued)
640x480 60/ 72/ 75 Hz
720x400 70Hz
800x600 56/ 60/ 72/ 75 Hz
1024x768 60/ 70/ 75 Hz
1280x1024 60Hz
1920x1080 60Hz
To Audio (R) Input