NEC Mobile Phone User Manual page 3

Road Safety
•
You MUST exercise proper control of your vehicle at all times. Give full attention to driving.
•
Observe all the recommendations contained in your local traffic safety documentation.
•
Pull off the road and park before making or answering a call if driving conditions so require.
•
You MUST NOT stop on the hard shoulder of a motorway to answer or make a call, except in
an emergency.
•
Switch off your phone at a refuelling point, such as a petrol station, even if you are not refuelling
your own car.
•
Do not store or carry flammable or explosive materials in the same compartment where a radio
transmitter, such as a cellphone, is placed.
•
Electronic vehicle systems, such as anti-lock brakes, speed control and fuel injection systems
are not normally affected by radio transmissions. The manufacturer of such equipment can
advise if it is adequately shielded from radio transmissions. If you suspect vehicle problems
caused by radio transmissions, consult your dealer and do not switch on your phone until it has
been checked by qualified approved installers.
Vehicles Equipped with an Air Bag
An air bag inflates with great force. Do not place objects, including either installed or portable
wireless equipment, in the area over the air bag or in the air bag deployment area. If in-vehicle
wireless equipment is improperly installed and the air bag inflates, serious injury could result.
Third Party Equipment
The use of third party equipment, cables or accessories, not made or authorized by NEC, may
invalidate the warranty of your cellphone and also adversely affect the phone's operation. For
example use only the NEC mains cable supplied with the AC charger.
Service
The cellphone, batteries and charger contain no user-serviceable parts. We recommend that your
NEC cellphone is serviced or repaired by an NEC authorized service centre. Please contact your
Service Provider or NEC for advice.
Non-Ionizing Radiations
The radio equipment shall be connected to the antenna via a non-radiating cable (e.g. coax).
The antenna shall be mounted in a position such that no part of the human body will normally rest
close to any part of the antenna unless there is an intervening metallic screen, for example, the
metallic roof.
Use only an antenna that has been specifically designed for your phone. Use of unauthorized
antennas, modifications or attachments could damage your phone and may violate the
appropriate regulations, causing loss of performance and radio frequency (RF) energy above the
recommended limits.
Efficient Use
For optimum performance with minimum power consumption, note the following:
•
Your phone has the internal antenna. Do not cover part of the internal antenna of the phone
with your hands. This affects call quality, may cause the phone to operate at a higher power
level than needed and may shorten talk and standby times.
ii Emergency Services and Safety Precautions
Radio Frequency Energy
Your phone is a low-power radio transmitter and receiver. When it is turned on, it intermittently
receives and transmits radio frequency (RF) energy (radio waves). The system that handles the
call controls the power level at which the phone transmits.
Exposure to Radio Frequency Energy
Your phone is designed not to exceed the limits for exposure to RF energy set by national
authorities and international health agencies. * These limits are part of comprehensive guidelines
and establish permitted levels of radio wave exposure for the general population. The guidelines
were developed by independent scientific organizations such as ICNIRP (International
Commission on Non-Ionizing Radiation Protection) through periodic and thorough evaluation of
scientific studies. The limits include a substantial safety margin designed to assure the safety of
all persons, regardless of age and health, and to account for any variations in measurements.
*Examples of radio frequency exposure guidelines and standards that your phone is designed to
conform to:
•
ICNIRP, "Guidelines for limiting exposure to time-varying electric, magnetic, and
electromagnetic fields (up to 300 G Hz)-International Commission on Non-Ionizing Radiation
Protection (ICNIRP)".
Health Physics, vol. 74. pp, 494-522, April 1998.
•
99/519/EC Council Recommendation on the limitation of exposure to the general public to
electromagnetic fields 0 Hz-300 GHz, Official Journal of the European Communities, July 12,
1999.
•
ANSI/IEEE C95.1-1992. "Safety levels with respect to human exposure to radio frequency
electromagnetic fields, 3kHz to 300 GHz". The Institute of Electrical and Electronics Engineers
Inc., New York, 1991.
•
FCC Report and Order, ET Docket 93-62, FCC 96-326, Federal Communications Commission
(FCC), August 1996.
•
Radio communications (Electromagnetic Radiation Human Exposure) Standard 2003,
Australian Communications Media Authority.
SAR certification information:
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Radio Frequency (RF) Signals (900/1800MHz)
THIS NEC PHONE (MODEL KMP6J1BK1-4E) COMPLIES WITH THE USA REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your mobile phone is a radio transceiver, designed and manufactured not to exceed the SAR*
limits** for exposure to radio-frequency (RF) energy, which SAR* value, when tested for
compliance against the standard was 1.39 W/kg. While there may be differences between the
SAR* levels of various phones and at various positions, they all meet*** the USA requirements
for RF exposure.
* The exposure standard for mobile phones employs a unit of measurement known as the
Specific Absorption Rate, or SAR.
** The SAR limit for mobile phones used by the public is 1.6 watts/kilogram (W/kg) averaged over
one gram of tissue. The limit incorporates a substantial margin of safety to give additional
protection for the public and to account for any variations in measurements.
*** Tests for SAR have been conducted using standard operating positions with the phone
transmitting at its highest certified power level in all tested frequency bands. Although the SAR is