Turning Your Phone On And Off; Displaying Your Phone Number; Using The Battery - LG Touchpoint TP5200 User Manual

Turning Your Phone ON and Off

Turning Your Phone ON
To turn your phone on, press
Once your phone is ON, it displays "Searching for Service" while you
phone looks for a signal. When you phone finds a signal, it automatically
enters Standby mode – the phone's idle state. At this point, you're ready to
begin making and receiving calls.
If you phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found,
your phone returns to Standby mode.
Your phone searches for a signal periodically without your intervention.
You can also initiate a search for service by pressing any key (when your
phone is turned ON).
Note:
The Power Save feature helps to conserve battery power when
you are in an area where there is no signal.
Turning Your Phone OFF
To turn your phone off, press

Displaying Your Phone Number

To display your phone number:
From the main menu, highlight
1.
Highlight and press
2. My Phone #
Section 2
10 Getting to Know Your Phone
for two seconds.
END
PWR
for two seconds.
END
PWR
and press .
Phone Book
OK
.
OK

Using the Battery

Battery Capacity
Your Touchpoint phone is equipped with a Lithium Ion (LiIon) battery.
It allows you to recharge your battery before it is fully drained. The battery
provides approximately 150 minutes of continuous digital talk time
(70 minutes in analog) or approximately 150 hours of continuous digital
standby time (16 hours in analog).
When the battery reaches 5% of its capacity, the battery icon blinks. When
there are approximately two minutes of talk time left, the phone sounds
an audible alert and then powers down.
Note:
Long backlight settings, searching for service, vibrate mode and
Browser use affect the battery's talk and standby times.
Tip: Be sure to charge your phone's battery and watch your indicator to
ensure your levels are okay.
Installing the Battery
Your phone comes with a LiIon battery. Follow these steps to install it:
Place the battery in the opening at a 45-degree angle with the metal
1.
contacts at the bottom, facing downward.
Gently press down on the battery until the latch snaps into place.
2.
Removing the Battery
To remove your battery, follow these easy steps:
Make sure the power is off so that you don't lose any stored numbers
1.
or messages.
Push the battery release latch up.
2.
Remove the battery from the phone at a 45-degree angle.
3.
Section 2
Getting to Know Your Phone 11