Philips FM24 Service Manual page 15

Component-side SCAVIO
Figure 4-3 Service position SCAVIO (2)
To access the other side of the SCAVIO panel:
1. Disconnect all cables going to the SCAVIO panel.
2. Remove all screws at the connectors of the connector
plate, see figure 'Solder-side SCAVIO'.
3. Remove the three fixation screws that connect the SCAVIO
panel to the connector plate, see figure 'Component-side
SCAVIO'.
4. Reconnect the SCAVIO panel, be careful: do not make a
short-circuit!
4.3.2 VGA Connector Panel
How to remove the VGA Connector panel:
1. Squeeze the plastic pins that attach this panel to the
SCAVIO board, while you pull it carefully upwards.
2. Unplug the flat foil cable.
4.3.3 Power Supply Panel
Figure 4-4 Service Position Power Supply
Mechanical Instructions
CL 16532099_043.eps
250901
B
CL 16532099_044.eps
270901
FM24
It is possible to perform most measurements at the component
level side (thus, the way the panel is mounted in the set).
However, to reach the copper side of the Power Supply:
1. Unplug the power cable.
2. Remove all eight fixation screws from the Power Supply:
three at each side and two in the middle.
3. Hinge the Power Supply forward, so that you can reach the
copper side. Use a non-conducting part underneath, to
support the PWB (e.g. a carton box). Caution: make sure
that, when you hinge the Power Supply forward, you do not
damage the cables. Pay special attention to the flat cable
(on connector 0307) and the cable on connector 0306,
because they can be easily damaged by the sharp edge of
the connector plate.
4. To remove the Power Supply, unplug all cables.
5. Remove the Power Supply.
4.3.4 Audio Amplifier Panel
The solder-side of this panel is directly accessible. To access
the component-side, or to remove the whole panel, unscrew
the three fixation screws (see figure 'Power Supply Panel'), and
(re)move the panel.
4.3.5 LED/Switch Panel and Speakers
Figure 4-5 Service Position LED/Switch Panel and Speakers
To access or replace the LED/Switch panel and/or speakers:
1. Take the monitor from its service stand, and put it (face
down) on a soft surface (blanket or foam cushion), to make
sure that you do not damage the front glass plate.
2. Unscrew all fixation screws of the plastic back cover: five at
all sides.
3. Lift and remove the plastic back cover.
4. You can access now the LED/Switch panel and/or the
speakers.
4. EN 15
Plastic backcover
Foam cushion
CL 16532099_045.eps
270901