Calling; Redial Previous Numbers; If The Number Is Busy; End Call - Siemens SL55 User Manual

Dialling with number
keys
The phone must be switched on
(standby mode) and the keypad
must be open.
J
Dial number (always with
area code, if necessary
with international dialling
code).
§Clear§
the last digit, a long press
clears the entire phone
number.
A
Press the Call key to dial
the number.

End call

B
Press End key briefly.
close slider fully.
Or
(This only ends the call
when the slider was
already fully opened)
Always press this key to end the call,
even if the person on the other end
of the line has hung up first.

Set volume

Using the plus/minus side key (press
top/bottom), adjust the volume (on-
ly possible during a call).
If a Car Kit is used, its volume setting
will not affect the usual setting on
the phone.
A short press clears

Calling

Redial previous numbers

To redial numbers that were dialled
previously:
A
G
A

If the number is busy

Automatic Redial previous numbers
§Auto dial§
Or
Call back
§Call back§
Reminder
§Prompt§
International dialling code
In standby mode, to insert international di-
alling codes from the list:
0
§+List§
Press the Call key once.
Pick out the required
phone number from the
list, then press ...
... to dial.
The phone number is au-
tomatically dialled ten
times at increasing time
intervals.
Your phone rings
when the busy number is
free.
A beep reminds you to re-
dial the displayed phone
number after 15 minutes.
Hold down until a "+" is dis-
played. This replaces the first
two digits of the international
dialling code.
Press, select country.
17
L