Cruise Control - Chevrolet Equinox2011 Owner's Manual

9-42 Driving and Operating
pedal. This is normal. Continue to
steer the vehicle in the intended
direction.
If there is a problem detected
with StabiliTrak, SERVICE
STABILITRAK is displayed on the
Driver Information Center (DIC)
and will stay on. See Vehicle
Messages on page 5 23. When this
message is displayed and/or
comes on and stays on, the vehicle
is safe to drive but the system is not
operational. Driving should be
adjusted accordingly. See Ride
Control System Messages on
page 5 27.
If comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If still comes on and stays on at a
speed above 20 km/h (13 mph), see
your dealer for service.
g
is located on the console.
Both StabiliTrak and Traction
Control can be turned off if needed
g
by pressing and holding
and come on the instrument
panel. When StabiliTrak is turned
off, the system will not assist with
directional control of the vehicle or
limit wheel spin. Driving should be
adjusted accordingly. Press and
g
release again to turn the system
back on.
If cruise control is being used when
StabiliTrak activates, the cruise
control will automatically disengage.
Press the cruise control button to
reengage when road conditions
allow. See Cruise Control on
page 9 42 for more information.
I n f o r ma t i o n P r o v i d e d b y :

Cruise Control

With cruise control, the vehicle can
maintain a speed of about 40 km/h
(25 mph) or more without keeping
your foot on the accelerator. Cruise
control does not work at speeds
below 40 km/h (25 mph).
If the brakes are applied, the cruise
control is disengaged.
g
until
If the vehicle has the StabiliTrak
system and begins to limit wheel
spin while using cruise control, the
cruise control automatically
disengages. See StabiliTrak
System on page 9 41 or Traction
Control System (TCS) on
page 9 40. When road conditions
allow you to safely use it again, the
cruise control can be turned
back on.
®
®