Preferences Dialog; General Tab; Audio Tab; Interface Tab - M-Audio NRV10 User Manual

5 Preferences Dialog

Preferences Dialog
To open the
Preferences Dialog
includes four tabs. The features available in each tab are outlined
below:
5.1

General Tab

•
Show Splash Screen: When this preference is checked, NRV10 interFX displays a splash screen
on start-up.
•
Start Processing (Power On): When this preference is checked, NRV10 interFX starts processing on
start-up.
•
Reload Last Program: When this preference is checked, NVR10 interFX loads the last loaded
Program
on start-up.
•
Show Effects After Program Load and Tile Them: When this preference is checked, NRV10 interFX
automatically opens all Effect Editors on
of this preference, sets the tiling method (vertical or horizontal).
5.2

Audio Tab

•
Sample Rate Selector: This drop-down control offers a choice of sample rates at which to run
NRV10 interFX, and the NRV10 Mixer.
•
Control Panel Button: Clicking the
Mixer. For complete documentation on the Control Panel, refer to the NRV10 printed manual. To
adjust latency in the Control Panel of the NRV10 Mixer, follow these steps:
1. Click the Hardware Tab of the NRV10 Control Panel.
2. Using the control labeled "ASIO/WDM Buffer Size," select the desired buffer size, and close the
NRV10 Control Panel.
3. Click the Close Button
•
Stop Audio if CPU Load is Over: When this preference is checked, NRV10 interFX stops processing
audio if the CPU load exceeds the set percentage. To set the desired CPU usage limit, enter a
percentage in the control located to the right of this option.
5.3

Interface Tab

•
Knob Mode Selector: This preference specifies the mouse gesture (circular or horizontal) used to
adjust the knobs of the NRV10 interFX user interface.
•
Show CPU Usage Indicator: Displays the current CPU usage in the
•
Show Control Tool Tips: When checked, NRV10 displays tool tips when mousing over controls.
5.4

Folders Tab

•
Data Folder Selector: This control selects the folder used by NRV10 interFX for storage and other
data. In most cases, you will not need to alter this setting.
•
Effect Folder Selector: This control selects the location of your VST plug-ins. By default, NRV10
interFX selects the default VST folder of your computer.
25
, choose "Preferences" from the
Program
Control Panel Button
of the Preferences Dialog
Options Menu
load. A drop-down control, located to the right
opens the Control Panel of the NRV10
.
Program Display
. The
.