Table of Contents
Advertisement
Basic connections
If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber,skip
ahead to page 14 for the proper connections.
ANTENNA TO DVD/VCR CONNECTION
The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV
and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting
an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection
diagram.
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
1
Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire
2
Separate VHF and UHF Antennas
3
VHF
NOTE:
If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300
ohm inputs and one 75 ohm output.
NOTES: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the
antenna to the DVD/VCR properly.
• For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of
an outdoor type antenna is required.
• If you are not sure about the connection, please refer to qualified service personnel.
12
75 ohm Coaxial Cable
Matching Transformer
300 ohm Twin Lead (Flat) Wire
UHF
300 ohm Twin Lead (Flat) Wire
75 ohm Coaxial Cable
300 ohm Input
75 ohm output
(not supplied)
Combiner
75/300 ohm Inputs
75 ohm output
(not supplied)
DVD/VCR
DVD/VCR
DVD/VCR
Advertisement
Table of Contents
