Electrical Adjustment - Sanyo VPC-CA6OR Service Manual

3. ELECTRICAL ADJUSTMENT

3-1. Table for Servicing Tools
Ref. No. Name
J-1 Pattern box (color viewer)
J-2 Calibration software
J-3 Chroma meter
J-4
Spare lump
J-5 Discharge jig
J-6 Collimator
J-6
Spare lump (collimator)
J-1
J-3
J-5
3-2. Equipment
1. Oscilloscope
2. Digital voltmeter
3. AC adaptor
4. PC (IBM R -compatible PC, Pentium processor, Window
98 or Me or 2000 or XP)
3-3. Adjustment Items and Order
1. Lens Adjustment
2. AWB Adjustment
3. CCD White Point Defect Detect Adjustment
4. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Note: Item 1-4 adjustments should be carried out in sequence.
Part code
Number
VJ8-0190
1
VJ8-0297
1
1 VJ8-0192
1 VJ8-0191
1 VJ8-0188
1
VJ8-0260
1 VJ8-0282
J-2
J-4
3-4. Setup
1. System requirements
Windows 98 or Me or 2000 or XP
IBM R -compatible PC with pentium processor
CD-ROM drive
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Installing calibration software
1. Insert the calibration software installation CD-ROM into your
CD-ROM drive.
2. Open the explorer.
3. Copy the DscCalDI_155 folder on the CD-ROM in the CD-
ROM drive to a folder on the hard disk.
3. Installing USB driver
Install the USB driver with camera or connection kit for PC.
4. Pattern box (color viewer)
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
the lump and its circumference are high temperature during
use and after power off for a while.
5. Computer screen during adjustment
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
PAF Cal.
OK
EVF
Cal Data
LCD Type
OK
USB storage
Get VID
PID
Set
Backrush pulse :
Get
3-5. Connecting the camera to the computer
This camera requires a DC adaptor (sold separately) in order
to use an AC adaptor.
1. Insert the DC adaptor to the camera.
2. Insert the AC adaptor's cable to DC terminal of the DC
adaptor.
3. Line up the arrow on the cable connector with the notch on
the camera's USB port. Insert the connector.
4. Locate a USB port on your computer.
5. If "USB CONNECTION" is displayed, choose the "CARD
READER", and press the SET button.
– 17 –
2
. Be careful of handling
LCD
R Bright
B Bright
RGB Offset Gain
Tint Phase
VCO
H AFC Test
Set Serial
Set
Set Rev. Set
Set
VCOMDC
VCOMPP
Hall Cal.
Setting
Language
Video Mode
Factory Code