Remote A/B/C/D Code Switching - JVC 3834RP0093F Owner's Manual

Remote A/B/C/D Code Switching

The remote control is capable of controlling four JVC
video units independently. Each of units can respond to
one of four codes (A, B, C or D). The remote control is
preset to send A code signals because your unit is ini-
tially set to respond to A code signals. You can easily
modify your unit to respond to B, C or D code signals.
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
TV
TV
DVD MENU MEMORY
REPEAT A-B
1
1
4
7
0
3
8
POWER
VCR DVD
1 - 2
SEARCH
SUBTITLE ANGLE
ZOOM TITLE REPEAT
SHOWVIEW
2 3
VIDEO Plus+
5 6
8 9
TV TV
TV/VCR
5
TV/VCR PR +
2
OK
0000
CANCEL
TV/VCR PR
4
On the remote control
Keep pressing VCR down during steps 1 – 2.
Change the remote control code.
1 1
Press the number key "1" for A, "2" for B, "3" for C
or "4" for D.
Set the remote control code.
2 2
Press OK to set the code.
On the unit
Turn off the unit.
3
Press I .
Display the code.
4 4
Press PLAY on the unit for over 5 seconds while
the unit is turned off. The code currently set appears
on the front display panel.
If the code displayed on the front display panel is
different from the code set on the remote control, go
to step 5.
Change the unit's code.
5 5
Press Á Á on the remote control. The code currently set
on the remote control will be applied to the unit.
Note
Once you have set the remote control to operate the TV,
you do not have to repeat this step until you replace your
remote control's batteries or until you pull out the power
cord.