JVC VR-N1600E Startup Manual page 22

Preparation
During Initial Startup
(continued)
6
Enter the password for the network camera
● Press the [KEY] button to display the software
keyboard.
● Use the keypad to move the mouse cursor over the
software keyboard.
● Pressing the [16/ENTER] button inputs the characters
on the keyboard into the password field.
7
After password entry is complete, press [KEY]
again the close the software keyboard
8
Use the [SKIP] button to select [OK], followed by
pressing [16/ENTER]
9
Repeat the steps from 5 to 7 for every detected
camera
● The [Camera Record Setting] screen appears.
10
Set the display rate of each camera such that
the total display rate of all cameras does not
exceed 80 ips
● The default display rate is set to 8 ips. In other words,
the maximum display capacity of 80 ips will be
exceeded if 11 or more cameras are automatically
detected. In this case, you will need to follow the steps
below to adjust the display rate of each camera.
Note :
● The recording rate may drop if the total display rate of all
cameras exceeds 80 ips.
A
Press the [SKIP] to select the Device Manager
●The device at the top of the list is selected.
B
Use the [2/D] and [10/0/E] buttons to select a device
A
B