Table of Contents
Advertisement
Functional Details
CIO-ERB24 and SSR-RACK24 daisy chain configuration
Many relay and solid-state relay (SSR) racks provide only 24-bits of digital I/O. You can configure the CIO-
ERB24 relay output board and SSR-RACK24 I/O module rack in a daisy chain configuration to use all of the
digital I/O bits provided by the PCI-DIO48H board. An example of the daisy chain configuration scheme for
each board is shown below.
The PCI-DIO48H provides digital I/O in a group of 48 bits. To use all of the board's 48 digital I/O bits to
monitor and control relays and/or SSRs, configure the daisy chain as shown in Figure 3.
Figure 3. PCI-DIO48H to CIO-ERB24 or SSR-RACK24 daisy chain
The 24 digital I/O bits on pins 1-24 control the second relay board on the chain. The 24 digital I/O bits on
pins 25-50 control the first relay/SSR board on the daisy chain.
82C55 emulation (mode 0)
The PCI-DIO48H emulates the 82C55 chip (mode 0). The 82C55 emulation initializes all ports as inputs on
power-up and reset. A TTL input is a high impedance input. If you connect another TTL input device to the
output, it could be turned on or off every time the board is reset.
To establish a consistent TTL level at power-up, use resistors tied to either +5V (pull-up) or ground (pull-
down). There are open locations for pull-up and pull-down resistor packs on the board.
Whenever an 82C55 emulation is powered on or reset, all pins are set to high-impedance input. Based on
standard TTL functionality, these inputs will typically float high, and may have enough drive current to turn on
external devices.
Consequently, if you have output devices such as solid state relays, they may be switched on whenever the
computer is powered on or reset. To prevent unwanted switching, and to drive all outputs to a known state after
power on or reset, pull all pins either high or low through a 2.2 K resistor.
PCI - DIO 48 H
CIO - ERB24
or
SSR - RA CK24
CIO - ERB24
or
SSR - RACK24
C50FF - x cabl e
IN
OUT
IN
OUT
13
Chapter 3
Advertisement
Table of Contents
