Failing In Reading A Barcode - FujiFilm Drypix 7000 Operation Manual

Troubleshooting
5.4

Failing in Reading a Barcode

When a film pack is replaced, this equipment reads a barcode affixed on the
film pack and manages the film lot number and other information.
[Fig. 5.29]
If, for any reason, the equipment fails in reading the barcode, an error window like that
shown below appears.
[Fig. 5.30]
Press the
placed correctly in the tray.
1 Does the label have red or green (DI-ML) arrow mark? Films other than with red or
green mark cannot be used. Replace with a correct film pack, and complete film
replenishment.
2 Is the film pack placed in the right position? (Fig. 5.29)
3 Is the film pack placed evenly?
If the film is not placed properly, replace it in a correct way, and push back the tray in.
If the same error recurs even though the film pack has been placed correctly, you can
forcibly continue the operation after it was removed.
006-235-50 2006.09
button to pull out the tray. Reconfirm then whether film pack is
1
back
of the
2
3
4
5
6
7
5-27