Job Tracking Setting - Panasonic DP-C406 Function Manual

Job Tracking Setting

This enables or disables Job Tracking. If Job Tracking is enabled, set the type of log to record, and the
Email address to which the log is to be sent.
Before performing this setup, you first need to register the destination Email address for the log in the Address
Book.
Furthermore, change the setting of "54 Fax Forward" (Fax/Email Settings > Fax Parameters) to "Invalid".
Set the POP Parameters to receive Emails automatically when using the Job Tracking function. Otherwise,
your machine cannot receive any Emails.
Make sure that the Fax Parameters are NOT set as below.
Auto POP Receive (Fax Parameter No. 147) : Invalid
POP Timer (Fax Parameter No. 146) : 0 minute
The Job Tracking setting is enabled when "Fax" and/or "Scan" is selected in the Authentication setting (See
page 12).
1
Press the Function key.
2
Select "Fax/Email Settings".
3
Select "04 Key Operator Mode".
4
Enter the Key Operator password (8
digits), and then select "OK".
1
The default password is "00000000".
To change the password, select "80 Key
Operator Password" in the General
Settings (Key Operator Mode), and then
enter the new password.
2
25