Table of Contents
Advertisement
Installation and Wiring
§
6
.
4
C
o
n
6
.
4
C
o
n
When using, for example, communication cable and optional equipment, connect them to the external
interface section. For details on the functions of the external interface section, see §5.4 "External
Interfaces."
Connect optional equipment before starting the UPS. If you want to connect optional equipment after
starting the UPS, completely stop the UPS, turn off the input power supply, and then connect the
equipment.
For details on wiring and settings, see §12. "Using Power Management Software" or the instruction manual
of the optional equipment.
For details on optional equipment, contact your supplier or SANYO DENKI.
REMOTE/EPO Terminal Connection Method
Connect and use, for example, a switch or a contact of the customer's system that matches the
terminal specifications.
For details on the functions of the terminals, see ⑤ of §5.4 "External Interfaces."
Terminal Connection Procedure
① Peel off the coating at the end of the wire
by approximately 9 to 10 mm.
② Insert the wire into the terminal while
pressing the tab with a flat-head
screwdriver.
③ Pull the inserted wire to make sure that it
does not come out.
Connect a SANYO LAN interface
card (option).
For details, see the instruction
manual of the LAN interface card.
Connect the supplied communication
cable and use the power management
software (on the supplied CD-ROM).
See §12. "Using Power Management
Software."
21
n
e
c
t
i
n
g
O
p
t
i
o
n
n
e
c
t
i
n
g
O
p
t
i
o
n
This completes the installation and wiring of the UPS.
a
l
E
q
u
i
p
m
e
n
t
a
l
E
q
u
i
p
m
e
n
t
Insert or remove a wire
while pressing the tab
with a flat-head
screwdriver or the like.
Compatible wires: AWG 26 to 20
Connect when using the external
transmission signal function. For details
on the functions of the connector, see ③
of §5.4 "External Interfaces."
If the conduction part
is short, a secure
connection will not be
possible.
Advertisement
Table of Contents
