Table of Contents
Advertisement
Basic operations
STANDBY indicator
STANDBY/ON
OPEN/CLOSE
ENTER
CHOICE
7
NOTE
Make sure that the KARAOKE - DVD
switch on the remote control unit is set to
KARAOKE
DVD
"DVD" when using the 5/∞/2/3 and
numeric buttons for controlling the unit.
About invalid operation icon
When you press a button, and if the unit does not accept its
operation,
appears on your TV screen. Operations are
occasionally unacceptable even if
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.
Turning on/off the unit
Press STANDBY/ON
unit or press
STANDBY/ON on the front
panel.
The STANDBY indicator on the front panel, which lights in
red during standby, goes off.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
NOW READING
Message area
• NOW READING (The unit is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the unit. The disc cannot be played back.)
• OPEN
• CLOSE
• NO DISC
6
0
7 3
STANDBY/ON
5/∞/2/3
3
DIMMER - KEY
is not displayed.
on the remote control
NOTE
Even if you turn off the unit, the unit is not disconnected from the
AC power source as long as it is connected to the wall outlet. This
state is called standby mode. In this state, the unit consumes a
very small amount of power.
Initial setup
When you turn on the unit for the first time after purchase, the
following message appears on the TV screen.
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO
SETTING
YES - PRESS ENTER
NO - CANCEL
You can set the display language, TV monitor type and digital
output before using the unit, by following the procedure below.
1
Press ENTER.
The first page of the DVD PLAYER SET UP display appears.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
DVD PLAYER SET UP
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
SELECT
USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
ON SCREEN LANGUAGE options
2
Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, CHINESE and
SPANISH.
3
Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
DVD PLAYER SET UP
MONITOR TYPE
PICTURE SOURCE
SCREEN SAVER
SELECT
USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
MONITOR TYPE options
4
Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9 NORMAL] or [16:9 AUTO]
(see page 27) .
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
CHINESE
SPANISH
4:3 L.B.
16:9 NORMAL
AUTO
16:9 AUTO
4:3 LB
ON
4:3 PS
16:9 MULTI NORMAL
16:9 MULTI AUTO
4:3 MULTI LB
4:3 MULTI PS
Advertisement
Table of Contents
