JVC MX-JD8 Service Manual page 33

3.5.2 Removing the front panel assembly
(See Figs.2 and 3)
• Remove the net assembly as required.
(1) Insert the tip of a flat-bladed screwdriver or similar tool into
the space between the front speaker main body and front
panel assembly, and lift the front panel assembly little by lit-
tle to remove the sections b. (See Fig.2.)
Note:
To prevent damaging the front panel assembly and front
speaker main body, insert cushioning plates etc. into the
space between the front speaker main body and front
panel assembly. (See Fig.2.)
(2) From the inside of the front panel assembly, disconnect the
red and black wires from the terminals of the tweeter. (See
Fig.3.)
3.5.3 Removing the tweeter
(See Fig.3)
• Prior to performing the following procedures, remove the front
panel assembly.
(1) Disconnect the wires (blue and white wires) from the termi-
nals of the tweeter.
(2) Remove the two screws A attaching the tweeter.
(3) Take out the tweeter from the front panel assembly.
Front panel assembly
Cushioning
plate, etc.
b
Fig.2
Wire(Blue)
A
Wire(Red)
Wire(White)
Terminals
Wire(Black)
Fig.3
Flat-bladed
screwdriver,etc.
Tweeter
A
Front panel assembly
(No.MB282)1-33