Sanyo PLC-XU55 Quick Start Manual page 2

Step Three: Turn on projector and computer
Turn on both units and
successfully complete this step, most likely you will not get an image from the projector.
Most PCs have a key combination that allows you to toggle through the various settings of the
built-in display and the port. Usually this is a combination of the Function key (Fn) and and another
key (such as F8). The key combinations vary from manufacturer to manufacturer and sometimes
model to model.
On the Macintosh, you have to go to the System Preferences: Display panel to adjust the settings.
You may have to go to the computer manufacturer's support web site to determine the correct
method for your computer.
Step Four: Set the Input source
Using the input button and arrow keys on top of the projector (see diagram below) to navigate
the on-screen menu, set the input source to match the port on the projector you connected to
in Step One.
Input button
set the computer to output through its VGA/DVI
On/Off button
Arrow keys and select button
Menu button
port. If you do not