Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Behmor Brazen
Summary of Contents for Behmor Brazen
-
Page 3: Important Safeguards
8. Do not use any attachment(s), and/or item(s) or make any modifications that are not explicitly approved by Behmor Inc. in, on or to the Behmor Brazen. Using such items or making modifications is strictly prohibited and automatically voids all warranties and relieves Behmor Inc. of any/all liabilities arising from such misuse and tampering. - Page 4 Start Button: For starting the brewing cycles and calibration. * Power Saving Sleep Cycle: The Brazen is programmed with a Power Saving Sleep Cycle. After 5 minutes of inactivity the system will go into this mode and the screen will dim. Press any button to bring the brewer out of this mode.
- Page 5 Programming Your Brazen The Brazen comes with default settings that are appropriate for brewing. Pre-Soak 15 seconds, Brew Temperature 200° F (90° C), and Altitude of 0 Ft. You can exit the programming modes at any point by hitting the “On/Off” button.
- Page 6 Altitudes for Major Cities in North America (Rounded to 250 foot increments used for programming the Brazen) Atlanta, GA – 876 ft. (750) Eugene, OR ‐ 423 ft. (500) Philadelphia, PA ‐ 203 ft. (250) Austin, TX ‐ 548 ft. (500) Indianapolis, IN ‐ 781 ft. (750) Portland, OR ‐ 617 ft. (500) Boise, ID ‐ 2651 ft. (2500) Kansas City, MO ‐ 755 ft. (750) Reno, NV ‐ 4534 ft. (4500) Boston, MA ‐ 20 ft. (0) Lexington, KY ‐ 997 ft. (1000) ...
-
Page 7: Brewing Instructions
Controlled Temperature Glide programming. 2. Remove the filter basket, and place ground coffee into the filter. A full pot of brewed coffee in the Brazen requires up to 16 Tablespoons of ground coffee (60-70 grams or 2 oz). If the Brazen’s gold filter is being used, finely ground coffee is not recommended as it may clog the filter. -
Page 8: Cleaning And Maintenance
*Note: The water can also be released before the system has reached the programmed temperature by pressing “Manual Release.” The heater will be turned off and the temperature will NOT be maintained in the reservoir. 5) Press “Manual Release” again to stop flow. The timer on LED screen will track how long the water flow has been stopped. - Page 9 Important Tips for Great-Tasting Coffee Coffee: The quality of the coffee used is directly related to the quality of the coffee brewed in the Brazen Brewer. The Brazen is, we believe, the finest brewer in existence but it can only deliver quality equal to the coffee used. We highly recommend buying fresh or commercially packed coffee that is sealed for freshness.
-
Page 10: Troubleshooting
Troubleshooting Problem Explanation Solution The display has gone dim The Brewer has gone into the Power Press any key to bring it out of this Saver mode. This is normal. mode. E0 – E6 One of the sensors has broken. Contact Behmor Technical Support. E7 The reservoir went dry while heating. Turn the system off. Allow to cool for 5 minutes. Turn on, add water to the reservoir and try brewing again. My coffee basket over flowed Either a ‐ The carafe must be in place when brewing. a ‐ The carafe was not in place. b ‐ Use a courser ground coffee. or If using the metal filter, try a cloth or b ‐ The filter clogged. paper filter. During calibration the water boils over This is normal. a minute. During calibration the lid bounces The lid should not be on during See Initial Set up and Cleaning – item calibration. 4). around. At the end of my brewing cycle You may be experiencing a reduction of ... - Page 11 Brewing Gold Cup Standard Coffee Specialty Coffee Association of America Gold Cup Standards: 1) 55 grams of ground coffee per liter (66 grams per 1.2L- Brazen) 2) Appx. 2 Tablespoons of ground coffee per 6fl. Oz. cup Specialty Coffee Association of Europe Gold Cup Standards: 1) 65 Grams of ground coffee per liter (78 grams per 1.2L-Brazen) or...
-
Page 12: Limited Warranty
WARRANTY WILL AUTOMATICALLY BECOME NULL AND VOID. Alleged defects caused by the failure to properly maintain the Brazen Brew System as referenced in the manual are not covered under the limited warranty. If you believe you have a warranty claim within the FIRST 30 days of the purchase date, please contact Boyd’s for a return label, a return authorization or a new part(s) to replace the defective one(s).
Need help?
Do you have a question about the Brazen and is the answer not in the manual?
Questions and answers