Advertisement
BEFORE PLAYING DISCS
Cleaning the CD
Before playing a CD, wipe it off with a clean, dust-free cleaning cloth.
Wipe the disc in the direction of the arrow.
Always insert the CD with the label side facing upwards.
If the CD is inserted with the printed side facing downwards, the device
may be damaged.
Note: If there is already a CD in the CD slot , do not try to insert a second
CD. This may damage the device.
Always hold CDs by the edge. In order to keep the CD clean do not touch
the surface. Pull out the CD as follows.
Do not attach any sticker or adhesive tape on the CD.
Do not expose the CD to direct sunlight or sources of heating.
Do not leave CDs in a car if it parked in direct sunlight as that will lead to
a considerable rise in the temperature inside the car.
Note: Do not use any solvents such as petrol or thinning agents. Commercially
available cleaning substances of antistatic spray will damage the device.
18
INSTALLATION
1
6
7
4
2
5
3
(
Fig
2
)
.
1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw
6. Strap
Be sure to use the strap to
secure the back of the unit in
place. The strap can be bent by
hand to the desired angle.
7. Plain Washer
2
3
2
INPUT THE SD CARD
The SD oblique angle keeps
rightward exposure
put into
,
the SD slot and press it again
to eject
.
Removing the unit
1
2
3
Fig
3
(
.
)
2.Insert fingers into the groove in the
front of fram e and pul l out to remove
the fram e. (When reatt achi ng the
frame , point the side wi th a groove
dow nw ards and attach it.)
3.Leve r
Insert the levers supp lied with the
uni t into the grooves at both si des of
the uni t and show n in figure unti l they
click. Pulling the levers makes possible
to remove the unit fro m the dashboard.
Fastening the unit to the factory
radio mounting bracket:
1. Select a position where the screw
holes of the bracket and the
screw holes of the main unit
become aligned (are fitted), and
tighten the screws at 2 places on
each side. Use either truss screws
(5 x 5mm) or flush surface screws
(4 x 5mm)
2. Screw
3. Dashboard or Console
DIN REAR-MOUNT (Method B)
Installation using the screw holes on
the sides of the unit
03
Advertisement
