Panasonic Viera TC-L42E30H Operating Instructions Manual page 70

Problem
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the
network
Cannot select the
file during DLNA
operations
Cannot access the
Internet contents
Due to the digital reception technologies involved, quality of the Digital TV signals may be
relatively low in some cases, despite good reception of Analogue TV channels.
Unable to receive
signals with a high-
performance aerial
Interference or
frozen / disappearing
image in Digital TV
The TV goes into
Standby mode
The remote control
does not work or is
intermittent
70
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the [HDMI1 / 2 / 3 / 4 Input] setting in the Sound Menu.
(p. 26)
•
If digital sound connection has a problem, select analogue sound
connection. (p. 63)
•
Check the HDMI cable is connected properly.
•
Turn the TV and equipment Off, then turn them On again.
•
Check an input signal from the equipment.
•
Use equipment compliant with EIA/CEA-861/861B.
•
Check the LAN cable or Wireless LAN Adaptor is connected properly.
(p. 47)
•
Check the connections and settings.
•
Check the network equipment and network environment.
•
If the problem persists, consult your Internet Service Provider or
telecommunications company.
•
Is the media server prepared?
•
Check applicable data format.
•
Check the connections and settings.
•
The server or connected line might be busy now.
•
Install an aerial individually for the TV and VCR (or use a splitter).
TV
Aerial Output
Aerial Input
terminal
Aerial Output
VCR
•
Check "Digital TV Signal Condition" (p. 31).
If "Signal Quality" is displayed in red, check aerial. If problem
persists, consult your local Panasonic dealer.
•
Turn the TV off with the Mains power On / Off switch, then turn it On
again.
•
Auto power standby function is activated.
•
The TV enters Standby mode about 30 minutes after analogue
broadcasting ends.
•
Are the batteries installed correctly?
•
Has the TV been switched On?
•
Point the remote control directly at the front of the TV (within about
7 m and a 30 degree angle of the front of the TV).
•
Situate the TV away from sunshine or other sources of bright light not
to shine on the TV's remote control signal receiver.
Actions
(p. 55, 59 - 61)
(p. 64)
(p. 47 - 50)
(p. 46)
(p. 65 - 66)
(p. 47 - 50)
(Individual aerial)
Splitter
Aerial Input
(Individual aerial)
(p. 6)