Table of Contents
Advertisement
10
DEVICE INSTALLATION
1. Connect the power cord
Insert the small end of the power cord into the Power Input port
Insert the small end of the power cord into the Power
Input port on the back of your Wireless Home
on the back of your Wireless Home Phone Base.
Phone Base.
Plug the power cord into an electrical wall
Plug the power cord into an electrical wall outlet
outlet that is not powered by a wall switch.
that is not powered by a wall switch.
2. Check the wireless signal
Raise the antenna in the upright position.
Signal Strength
Confirm signal strength light is green for
optimal performance. Yellow indicates a
moderate signal and may be sufficient.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Wireless Home Phone Base and is the answer not in the manual?
Questions and answers
How do i access my messages remotely
To access voicemail messages remotely on the Consumer Cellular Wireless Home Phone Base, dial your home phone number from a phone not connected to the base. Then follow the voice prompts to listen to and manage your messages.
This answer is automatically generated
Change number of rings on my verve home base
To change the number of rings, set your answering machine to pick up calls in fewer rings than the voicemail service, which is set to five (5) rings by default. The number of rings on the voicemail service itself cannot be changed from the device.
This answer is automatically generated