Table of Contents
Advertisement
2.3 PLUMBING INSTALLATION
Mapping out the plumbing installation is recommended since there can be variations to
the installation of the sensors and chemical feed equipment. This section gives the basic
principles to be applied for any specific installation, which are listed as follows:
Identify the new and existing equipment to be connected.
When controlling chemicals locate a location for the AK1200 flow cell (if purchased.)
Determine the water-tap points for the bypass inlet and outlet.
Install the bypass.
Install the pH and ORP sensors.
Test the plumbing for leaks.
WARNING: BE SURE TO HAVE A LICENSED PLUMBER PERFORM ALL PLUMBING; THIS IS
IMPORTANT, AS THEY WILL BE FAMILIAR WITH ALL THE CODES IN THE LOCAL AREA.
S
-R
I
TA
ITE
NSTALLATION
& O
G
PERATION
UIDE
8
Advertisement
Table of Contents
