Table of Contents
Advertisement
3.13
OVERFEED TIME LIMIT
The Overfeed Time Limit allows you to set the maximum amount of time that a feeder will
be allowed to be on during a 24-hour period. The time is accumulative over the period of
the day and will be reset to zero once in any 24-hour period or when the unit is powered
on and off.
Note: The time setting for this reading is in Hours and has a maximum time limit of 23
hours.
pH
To set the pH Overfeed Limit press the pH menu button five times. Then press the +
button to increase the Limit time or press the – button to decrease the time. To change the
ORP Overfeed limit press the ORP menu button five times. Then press the + button to
increase the Limit time or press the – button to decrease the time.
4.0 ADVANCED MENU
Under normal operating conditions you should not need to go into the advanced menus. If
you do need to access the advanced menus press both the + and – buttons
simultaneously. (When in the advanced menu all five of the LED 's will turn ON.)
While in the advanced menu you can scroll through the readings by pressing the ORP
MENU button. The menu items that can be accessed and changed are:
1. Clear pH (CLr PH): Clears the ph calibration back to factory default.
2. Clear ORP (CLr OrP): Clears the ORP calibration back to factory default.
3. Acid(Acd) or Base(bAS): Allows you to select either Acid feed or Base feed for the
pH chemical feed pump.
4. Set Password (Spd): Allows you to set a password code to control access to the
menu displays. Once a password is set access to all except the readings screen will be
blocked until this set password is entered.
5. Reset ALL (RSt ALL): Resets ALL programming and settings to factory defaults.
S
-R
I
TA
ITE
NSTALLATION
pH
pH
Flow
FEED
ALARM
ORP Overfeed Time Limit Display
& O
G
PERATION
UIDE
015
ORP
ORP
ORP
ALARM
FEED
19
Advertisement
Table of Contents
