Drive Installation; Verification Of The Installation - Mitsubishi MF357G Installation Manual

Drive Installation

1. IDE Interface
Connect the IDE cable between the drive signal interface and IDE controller. Make
sure that the each of connectors is properly inserted and secure. The interface cable
has a coloured marking to indicate Pin 1. Check that this coloured marking
corresponds to Pin 1 of the drive's IDE connector and Pin 1 of the IDE controller.
2. Power Interface
Connect the Power cable to the 4-PIN Power connector on the drive, making sure
that the connector is inserted with red coloured lead at the right-hand (outer) side of
the connector when the drive is viewed from the rear.
The LS-120 has a 3.5" floppy disk drive (FDD) type connector for its power interface.
Use an adaptor if the larger HDD type power connector is the only type available.
3. Securing the drive
Secure the drive into the bay by recommended screws.
Drive Model
MF357G-xxxUx
MF357G-xxxMx
Caution:
Do not use screws of excessive length. They may cause
damage to the circuit board of the drive.

Verification of the Installation

Before you put the cover of the computer back:

Verify that the power and data connections are secure and have the correct
orientation, the jumper setting is correct and that screws are tightly fastened.

Check cabling to avoid any possible damage that may be caused if the cable is
trapped between the PC's chassis and cover.
Mitsubishi Electric Australia Pty Ltd
Recommended Screws
#6-32x1/4", Depth = 4 mm (imperial)
ISO M3, Depth = 4 mm (metric)
6