Jumper Settings; Some Common Configurations - Mitsubishi MF357G Installation Manual

Jumper Settings:

MA
E1
SHORT OPEN
OPEN SHORT
OPEN OPEN
DO NOT use the MD0 setting (E4), this is for factory use only.
The CABLE SELECT setting is not used with IBM or compatible PC systems.

Some Common Configurations

Primary IDE
Master
HDD
HDD
HDD CD-ROM
HDD CD-ROM
Connection Examples:
a) If you have two IDE controllers, find an unused connector. The main IDE
hard disk drive (drive C:) will usually be the Primary Master. CD-ROM
drives are often set as the Master device for the Secondary IDE controller.
If this is the case, select the Slave setting on the LS-120 (by setting the
jumper to "SL") and connect the LS-120 to either IDE controller.
b) If you have two IDE controllers, but only the Primary is used (for example
with the hard disk as Master and CD-ROM as Slave), select the Master
setting on LS-120 (set the jumper to "MA") and connect it to the secondary
IDE controller.
c) If you have only one IDE controller, with one unused IDE connector, set the
LS-120 as the Slave device, connected to the same cable as the hard disk
drive.
Mitsubishi Electric Australia Pty Ltd
SL CS
E2 E3
OPEN
OPEN
SHORT
Existing Devices
Secondary IDE
Slave Master
CD-ROM
HDD
DRIVE CONFIGURATION
MASTER DRIVE
SLAVE DRIVE
CABLE SELECTS MASTER/SLAVE
New LS-120 Connection
Slave
Secondary Master
Primary or Secondary Slave
Secondary Master
Secondary Slave
5