Table of Contents
Advertisement
Unpack all piano stand pieces and hardware prior
to beginning assembly.
You should have the following hardware:
(4)
Hand knob bolts
(4)
Plastic caps
Bag #3
(1)
Headphone bracket (plastic)
(2)
Small wood screws
Bag #4
EXTRA PARTS
(1)
Hand knob bolt
(1)
Plastic cap
(1)
Fuse
7. Attach the headphone hanger to the inside left leg about
midpoint near the front edge of leg. Remove adhesive
backing on the bracket and insert the two (2) small wood
screws through the bracket. Align tips of screws with
holes and then press bracket into place. Tighten screws
but
DO NOT OVERTIGHTEN
and tighten. Repeat for the remaining (3) mounting holes.
10. Insert sustain pedal cable in socket under the keyboard as marked, route the cable under
the base and insert pedal in the front base cavity.
11. Plug AC cable into plug under the keyboard (marked) observing
the previous page.
(varies)
as the bracket will crack easily.
7
ASSEMBLY
(Read Before Starting)
1. Place pedal base with pedals pointing
up and underside of base facing you.
2. Place left leg on its back edge and
align holes in leg with holes in pedal
through leg, tighten and insert
decorative plastic caps.
inside of each leg should have the
back cutout facing inward as well as
have (6) tapped screw holes visible
Diagram (1)
3. Repeat above for right leg.
inside of each leg using three (3)
bracket.
Diagram (2)
5. Fit the modesty panel to the back of
the base between the legs aligning
the pre-tapped holes ith the bottom
and sides. Attach with seven (7)
6. Carefully stand base up.
If you align the top as described,
Safety & Precautions
Note
: The
to the top
Diagram (3)
of
Advertisement
Table of Contents
