Installing Your New Unit; Basic Connection - JVC HR-XVC23U Instructions Manual

14
EN

Basic Connection

Antenna or Cable
Coaxial cable
Flat feeder
AC Outlet
AC Power Cord
Back of unit
Audio/video cable
(supplied)
To Audio/video
input connectors
Matching transformer
(not supplied)
AUDIO
OUTPUT
VIDEO OUTPUT
VHF/UHF
IN
VHF/UHF OUT
RF cable
(supplied)
To 75 ohm
Terminal
TV

INSTALLING YOUR NEW UNIT

It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 87.
B
Situate the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to TV.
A Disconnect the TV antenna from the TV.
B Connect the TV antenna cable to the VHF/UHF IN
connector on the rear panel of the unit.
C Connect the supplied RF cable between the VHF/UHF
OUT connector on the rear panel of the unit and the
TV's antenna terminal.
D Connect the supplied audio/video cable between the
AUDIO/VIDEO OUTPUT connectors on the rear
panel of the unit and the TV's audio/video input
connectors.
Set your TV to AV mode.
For switching the TV's mode, refer to the instruction manual of
your television.
To obtain high-quality pictures, you can also use the S-VIDEO
connection or Component Video Connection. (DVD deck
only) ( pg. 15, 16)
D
Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet. This
unit performs Plug & Play Set automatically. (
The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet. (If "AUTO" and the channel
indicator are displayed on the front display panel before the
unit is powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the unit.)
pg. 17)