Accessories/Optional Accessory - Panasonic TC-P54Z1 Operating Instructions Manual

Accessories/Optional Accessory

Check you have all the items shown.
Accessories
Remote Control Batteries for the
Transmitter Remote Control
N2QBYB000005
Transmitter (2)
AA Battery
Tuner Box Cable clamper (2)
TU-Z100U
Operating Instructions Product Registration Card
(U.S.A.)
Viera Concierge and basic Customer Care Plan Card
instruction for HDTV (U.S.A.)
Wireless Unit set p. 11 Speaker set
(Receiver and Transmitter)
Optional Accessory
Note
In order to maintain the TV's performance and safety, be absolutely sure
to ask your dealer or a licensed contractor to secure the wall-hanging
brackets.
Carefully read the instructions accompanying the plasma TV stand or
pedestal, and be absolutely sure to take steps to prevent the TV from
tipping over.
Handle the TV carefully during installation since subjecting it to impact
or other forces may cause its panel to crack.
Wall-hanging bracket
(vertical)
TY-WK5P1SW
Installing the remote's batteries
Pull open
Hook
8
Accessories
Cleaning cloth Pedestal
TBLX0107
How to assemble
(p. 9)
RS232C terminal
Specifications
p. 10
Caution
Incorrect installation may cause battery
Close
leakage and corrosion, resulting in
damage to the remote control.
•
Do not mix old and new batteries.
•
Do not mix different battery types
(such as alkaline and manganese
batteries).
•
Note the correct
Do not use rechargeable (Ni-Cd)
polarity (+ or -).
batteries.
Do not burn or break batteries.
Do not disassemble or modify the
remote control.
Attaching the pedestal to TV
■
Assembling the pedestal
Be careful not to scratch the surface (part with
gloss finish) of the base during assembly
Remove the cable cover attached to the
frame. (It will be used again after the pedestal
is attached to the display Unit.)
Fix securely with assembly screws . (Total 2 screws)
A
Tighten screws firmly (tightening torque: 1.8 - 2.0 N• m)
Hole for the base installation
A
Base
■
Set-up
Attach the pedestal to TV
Slide the pedestal frame posts into the brackets on the back of the TV.
Fix securely with assembly screws . (Total 4 screws)
C
Tighten screws firmly (tightening torque: 1.5 - 1.8 N• m)
Pedestal
Holder cover
B
Attach the cable cover
Cable cover
Cable
Hole
Tabs
Insert the tabs of the
cable cover into the hole at
the back of the pedestal.
Accessories
Frame
Assembly screws
A
Cable cover
M8 × 30 (Silver) (2)
B
M4 × 10 (Black) (4)
C
M5 × 25 (Black) (4)
Base (1)
Frame
Frame (1)
Base
Holder cover (1)
C
Attach the Holder cover with assembly screws .
B
(Total 4 screws)
Place each cable in the groove at the back of the
pedestal and snap the cable cover in.
* The lower part of the groove is separated in right
and left. Use the one suitable for you.
9