Connecting The Power Cord; Installing Batteries In The Remote Control Unit - JVC XV-1000 XV-1000BK Instructions Manual

Connecting the power
cord
Installing batteries in
the remote control unit
Connect the power cord after all the connections have been made. Be sure to insert
the power cord firmly.
Warning
• Disconnect the power cord if you are not going to use the player for a long time.
• Disconnect the power cord before cleaning the player.
• Unplug and remove the power cord from the player and the wall outlet before
moving it.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord
and cause fire, electric shock, or other accidents.
Caution
• Do not damage, remodel, twist, or pull the power cord, as this may cause fire,
electric shock, or other accidents.
• Contact a dealer and get a new power cord if the cord is damaged. A damaged
cord may cause fire, electric shock, or other accidents.
• Do not put anything heavy or this player on the power cord, as this may cause
fire, electric shock, or other accidents.
The battery compartment is located on the back of the remote control unit.
1. Press down on the triangular
mark of the compartment cover,
and slide the cover off to open the
compartment.
2. Place the two accessory R03 (UM-
4)/AAA (24F) batteries in the
remote control according to the
polarity markings ("+" and "–")
inside the compartment and on
the batteries.
3. Place the cover over the com-
partment, press down lightly,
and push it upward until it snaps
on.
Before Using for the First Time
13