Advertisement
STEP 4
Load Two Tracks
On the left touch screen (TRACK A), swipe left
to the File Browser screen. Navigate to the folder
named "GO-DJ™ Drive". You can either double-
tap on the folder on the touch screen, or rotate the
"FUNCTION A" controller and then press it when
the folder is highlighted. In this way, navigate to one
of the audio files that you loaded into the GO-DJ™.
Double-tap it on the screen or highlight and click it
using the "FUNCTION A" controller. You will then
see a dialog box: click "Load".
STEP 5
Make Some Noise
Press the left Play/Pause button. You should
hear TRACK A in your speakers. You can listen
on your headphones as well. To change the
overall headphone volume, press and turn the
VOLUME-B controller.
TROUBLESHOOTING
If you don't hear anything, here's what to do:
Turn up the VOLUME A controller. (The ring of LEDs
around it will be completely lit up in blue when
the volume is at maximum.) Also check that the
cross-fader isn't all the way over to the other side...
the side you are not playing. If you still can't hear
anything, check the master volume as follows:
STEP 6
Cue a Track in Your Headphones
Notice the light blue headphone icon,
beside the battery level indicator in
the top right corner of the left screen.
While keeping an eye on it, press the VOLUME-A
controller.
In this way, you can independently route either
track to one or both ears of your headphones. If
you're not sure what to do, may we suggest you set
up "split cueing": route TRACK A to your left ear (by
pressing the VOLUME-A encoder), and TRACK B to
your right ear.
The first time the GO-DJ™ sees a new track, it
automatically analyzes it to determine the tempo. If
you have just loaded up your GO-DJ™ with a bunch
of tracks, you might encounter a little latency at this
point while the tempo mapping takes place. This
only happens once for each new track you load.
Load a track into the right channel (TRACK B) in
the same way.
For More Info There's a way to set up the headphone jack so that
it has the same output as the main mix. Please check the manual.
Rotate the FX SELECT controller clockwise until
the last LED around it is lit up in green Then rotate
the FX LEVEL controller (which is now acting as the
master volume) clockwise to increase the Master
Volume level.
You will notice that the right side of the
headphone icon dims (turns dark gray),
and that you can now hear the track only
in your left ear.
When you press this controller again,
the left side dims, the right side turns
back to light blue, and the track can be
heard only in your right ear.
Press the VOLUME-A controller again and the
track is not routed to your headphones at all.
Finally, press the controller once more and the
track is routed to both ears again
4
Advertisement
